top of page

heavy duty equipment technician

PayPal ButtonPayPal Button

$70.00

Each Red Seal Exam Trade Package is available for:

All files will be emailed to you same day.

Our Heavy Duty Equipment Technician Red Seal Exam package contains 783 multiple choice questions and answers to give you the most complete exam package to help you prepare for your Inter-Provincial Red Seal Exam.

 

Heavy Duty Equipment Technicians inspect, service and repair the brakes, engines, drive trains, steering and suspensions, fuel, emission control and exhaust, cooling and climate control, electrical and electronic systems using hand tools and other specialized repair equipment along with other parts of trucks and heavy machinery. They also perform routine maintenance to prevent future breakdowns. They also require a thorough knowledge of truck mechanical, hydraulic, and air braking systems. Good knowledge with a variety of electronic tools, such as infrared engine analyzers and computers. 

 

You will receive all our modules emailed directly into your inbox same day so you can begin studying immediately. This allows you to open the files on any Computer,

I-Phone or Android device directly from your email inbox so you can study at your own pace anywhere at anytime without the worry and pressure of expiring limited online sessions. All modules have been developed in PDF and are printable if required.

​

Safe working practices and accident prevention are the primary importance to the health and safety of all person(s) at any or all work place environments. All person(s) including employee, employer and government, share this responsibility in order to keep everyone free of any dangers or accidents that may cause an individual(s) serious bodily harm or death. Practicing health and safety is a tremendous contribution to a safe and accident free work place environment.

 

Sample Questions

 

1. Which of the following would be the fault on a hydrostatic drive system that will operate in reverse but not in forward?

a. Drive motor overloaded.

b. Servo pistons are scored.

c. Low charge pump pressure.

d. Pressure relief valve stuck open.

Ans. D

 

2. In basic fluid coupling, the least slippage between the impeller and the turbine occurs at the?

a. high engine speeds

b. low engine speeds

c. low engine temperatures

d. high altitudes

Ans. A

 

3. What will happen if the service air line comes apart while you are driving a combination vehicle but the emergency line stays together?

a. The emergency tractor brakes will come on.

b. Nothing is likely to happen until you try to apply the brakes

c. The trailer's air tank will exhaust through the open line.

Ans. B

 

4. If the housing drain port is blocked while the pump is operating at high pressure, which of the following will happen to an inline axial piston pump?

a. shaft seal will fail and start leaking.

b. force between the shoe and swash plate will increase.

c. inlet pressure will drop and cause the pump to cavitate.

d. Leakage into the housing will decrease as housing pressure increases.

Ans. A

 

5. Which of the following should be done before replacing a steering cylinder on an articulating loader?

a. Drain hydraulic reservoir and remove hydraulic cylinder.

b. Relieve pressure from cylinder lines and remove cylinder.

c. Disconnect battery and release brakes.

d. Thoroughly clean around cylinder and install safety lock bar.

Ans. D 

 

 

Get the most complete exam information package today, easily & affordably from         Red Seal Exam Trades Group and pass your Inter-Provincial Red Seal Exam with confidence!

PayPal ButtonPayPal Button

$70.00

Each Red Seal Exam Trade Package is available for:

All files will be emailed to you same day.

Contractors State License Exam
bottom of page